Dual Toyota small square switch ON/OFF
This 12 volt push switch is dual ON-OFF switch designed to operate your 12 volt accessories. it has a face surface size of 22mm x 22mm, and uses the original mounting hole of the vehicle.
This Switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.
- Single Pole Single Throw ON-OFF PUSH switch
- Single Input Dual Output
- Black hard surface.
- Laser etched Legend
- DUAL upper L.E.D light in blue.
- DUAL lower L.E.D light in blue.
- One Light is ON when the switch is pressed IN.
- One Light can be wired to separate dash light circuit.
- Rated at 3Amp 12V.
- Wiring diagram supplied with switch.
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
The switch is an electronic switch rated at 3amp's. Therefore in ALL cases the accessory MUST be wired through a fused relay.
Toyota Switches
Rear picture showing terminals and wiring harness supplied with switch.
Toyota Switches Illumination
When switch is pressed in the green light illuminates.
The top light (image) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.
(this is a sample image with the LED LIGHT BAR and SPOTTIES logo)
VEHICLE COMPATIBILITY
This Switch Suits the following Toyota models ONLY:
LandCruiser 300s |
2022 - Onwards |
Prado 150s |
08/2017 - Onwards |
RAV4 & RAV4 Hybrid |
01/2019 - Onwards |
Camry 70 Series |
09/2017- Onwards |
Hiace |
02/2019 - Onwards |
Corolla |
06/2018 - Onwards |
LandCruiser 70s |
2024 - Onwards |
Installation Info
In all cases a FUSED RELAY MUST be used in the installation of this switch.
This switch is an electronic switched circuit and will stand a maximum of 3 amp draw.
It is important that a correctly fused and wired relay is used.
we always suggest using a qualified auto electrician.
Wiring Diagram
Wiring:
- + yellow : power in
- + green : power out top switch via relay
- + Blue : Power out bottom switch via relay
- + Red : to dash light
- - Black : to earth