EasyAs alternator sensing ignition source is one of the easiest ways to find an ignition source in a vehicle when wiring up devises requiring ignition or control connections.
Description
Finding a suitable ignition source in modern vehicles can be a royal pain in the butt. At best it is difficult, time consuming and expensive, and at worst it can be disastrous as errors through backprobing or loading sensitive circuits in modern Canbus vehicles can cause critical damage to sensitive equipment and computers.
A few products have been developed to try and solve this problem, but these have been expensive and difficult to fit. Determined to provide a solution, the engineers at GSL Electronics have developed an easy to fit alternator sensing ignition source relay, or EasyAS for short.
Unique and patented technology embedded in EasyAS monitors electrical waveforms and can sense when an alternator is operating, and therefore indicate that the vehicle’s engine is running. This intelligence allows a simple relay switch to power all manner of electrical acesories in any vehicle without interfering with the original equipment wiring. All EasyAS requires is a positive battery current source.
Designed to fit into a standard four or five-pin relay holder, it can be fitted within minutes, in any small space under the bonnet or close to the accessory. The electronics are sensitive and dependable enough that it can be fitted at the rear of a car, trailer or caravan and provide a reliable ignition source signal without the need to run metres of additional cable.The GSL EasyAS is 12 or 24 volt compatible and will operate with all modern vehicles including those equipped with smart alternators. It also comes complete with Voltage Sensing Relay (VSR) and manual override modes to broaden the range of potential applications.
Features
easy installation. As easy as 1, 2, 3.
Optional On/Off control at the device
can be configured in Voltage Sensing Relay (VSR) mode
can direct drive loads up to 8A
Designed to fit standard 5 pin relay sockets
Installation
1. Mount the unit in a dry, moisture free environment away from inflammable materials. eg. Fuel lines or Exhaust systems
2. If using a socket or spade terminals. Make sure they are tight and secure.
3. Mounting can be done via the provided 5.5mm eyelet hole for screw mounting at the top of the unit. If mounting alternatively use best practice and common sense.
4. Connect using the 1,2,3 procedure
Dimension & Specification
EasyAS has very compact dimensions, and a sturdy design. universal socket leg model so that it fits all relay sockets on the market. There is a slot for bolts for easy installation anywhere
EasyAS
Specification
Voltage
12V/24V
Current
8A
Dimensions
(mm)
80x30x30
(H x Wx D)
Choosing a selection results in a full page refresh.
Press the space key then arrow keys to make a selection.
Use left/right arrows to navigate the slideshow or swipe left/right if using a mobile device